ring and Bulkhead designed by Ready Board manufacturer

内容：

The ready board manufacturer of Ready Board with Wiring and Bulkhead shall follow certain technical requirements during production to ensure the performance, quality and technology of Ready Board with Wiring and Bulkhead. The following is a brief introduction by the Ready Board with Wiring and Bulkhead factory:

1. The leakage switch in the Ready Board with Wiring and Bulkhead adopts electromagnetic products, such as Schneider, ABB, Mueller, Chint and so on. There is enough space for wiring in the box and independent zero line and ground wire terminals. Samples shall be sent to Party A and the supervising engineer for approval before production.

2. The main switch to the sub switch of the Ready Board with Wiring and Bulkhead manufacturer shall be connected with copper bar (no bare conductor) and meet the acceptance requirements of the specification, and shall not be connected with copper wire; The cross section of outgoing wire of main switch shall not be less than that of incoming wire; Circuit labels shall be typed with plastic strips and fixed firmly.

The main purpose of designing the circuit of the Ready Board with Wiring and Bulkhead is to make the inside of the Ready Board with Wiring and Bulkhead look clean and tidy, and to improve the safety factor.

When transporting the Ready Board with Wiring and Bulkhead, we need to protect it. In the outer layer, we can use the wooden box for packaging. In the gap between the wooden box and the box, we can use foam board to fill and fix it firmly, so as to ensure that the Ready Board with Wiring and Bulkhead will not have a large displacement during transportation.