"The aging of the Split Metered Distribution Board actually refers to the aging of the lines of the Split Metered Distribution Board. After a certain number of years, the lines can no longer be used normally," said the person in charge of the Split Metered Distribution Board brand, "In addition, high temperature baking, sunlight and corrosive harsh environment will directly lead to the shortening of the service life of the Split Metered Distribution Board line, and even the cracking, blackening and decomposition of the line insulation layer, which will cause short circuit, high local heating, high temperature, melting the insulation layer, igniting the surrounding combustibles, and then causing a fire". Both enterprises and individuals should pay attention to the fire caused by the aging of Split Metered Distribution Boards and circuits, and take some practical and useful measures to eliminate the potential fire hazards. In normal daily life, citizens should check whether the electrical lines in the residence are safe, try not to pull and connect the lines privately, and take measures to protect the leakage of lines in the kitchen, bathroom and other wet parts of the residence. Install circuit breakers and fuses, and it is strictly forbidden to use copper wires and aluminum wires to replace fuses. It is best to ask professionals to install household circuit changes to prevent fire hazards.

The aging meter box should be replaced in time to avoid the short circuit caused by the aging wire and the burning of the meter. Secondly, check the use of the Split Metered Distribution Board regularly to see if the heat dissipation is good. Don't put combustibles too close to the heat source. In particular, check whether the Split Metered Distribution Board is overloaded. Try to avoid using multiple high-power Split Metered Distribution Boards at the same time. Try not to use household Split Metered Distribution Boards in thunderstorms. Everyone should keep an eye on it at ordinary times. Once you smell a pungent smell of burning rubber and plastic at home, it may be an electrical fire. At this time, you should investigate the cause as soon as possible and repair it in time. After confirming that the Split Metered Distribution Board is on fire, switch off the power immediately. If the household Split Metered Distribution Board such as TV and induction cooker is on fire, do not pour water on the Split Metered Distribution Board, and use dry powder fire extinguisher or carbon dioxide fire extinguisher to put out the fire. In case of emergency, the Split Metered Distribution Board can also be covered with soaked bedding to achieve the purpose of extinguishing the fire. In case of fire, several escape rules should be kept in mind: touch the door before opening the door. If the door has been heated or smoke is found entering through the crack of the door, do not open the door, and prepare the second escape route; Escape from one room to another, and close the door after arriving; If the exit passage is blocked by smoke and there is no other route to go, you should be close to the ground and crawl through the smoke area.