Ready Board manufacturer direct sales today to share with you the operation process and precautions of low-voltage distribution cabinet when stopping and transmitting power. Voltage distribution facilities are common in our life and closely related to our life. As an important member of low-voltage distribution equipment, low-voltage distribution cabinet is mainly used for power conversion and control of lighting and distribution.

Because it belongs to power equipment, it will always cause equipment failure or personal safety due to misoperation. Therefore, operation specification is very important, especially in the process of power shutdown and transmission, strict operation process is more important. Metal parts of Ready Board and cabinet:

The Ready Board is directly sold by the manufacturer, including the installation board, support and metal shell of electrical appliances, which are well grounded. Electrical appliances are installed at the doors and laying boards of Ready Boardes and cabinets. When they can be opened, they can be reliably connected with the grounding metal frame with bare copper flexible wire through transparent plastic pipe.

If the plate thickness of the concealed packing box is less than 3mm, a full length -- 40 shall be attached at the back of the left side of the box × 4 galvanized flat steel, 15cm longer than the box at both ends. If the thickness of the box plate is greater than 3mm, weld one piece at the upper and lower ends of the left back of the box (the welding length of galvanized flat steel when welding with the box shall meet the specification requirements) - 40 × 4 galvanized flat steel, 15cm beyond the box.

One L40 shall be laid at 10cm above and below the middle of the left and right sides of the Ready Board manufacturer's direct concealed box × four × 50 angle steel (used for fixing the box when ready for installation). These are several important elements when selecting the distribution cabinet. Of course, there are others that need your attention, such as the brand of components, the qualification of manufacturers, industry reputation, etc.